Skystars H743HD FlightControl X8 and KO60 60A Blheli32 4IN1 ESC Spec

9 Comments

1. 

   Shivam Gupta
   2023年 3月 20日

   Please add to inav firmware sir
   I request you I want to add compass in it with inav please

   Reply
2. 

   Shivam Gupta
   2023年 3月 31日

   Please add inav firmware for this fc please sir I want to use compass on it hello sir please add

   Reply
3. 

   Konst Karapan
   2023年 6月 27日

   I’m confused. In the specifications the only targets are betaflight and ardupilot. In the inav firmware flasher tab, however, there is a target called:”SKYSTARSH743HD”. Does this mean that the fc supports inav and the skystars site is out of date or the target is for another fc?

   Reply
   1. 

      pika
      2023年 6月 27日

      It is for the H743 flight control, recently updated with the new INAV firmware

      Reply
      1. 

         pika
         2023年 6月 27日

         yes

         Reply
4. 

   Konst Karapan
   2023年 7月 16日

   What’s the maximum amperage I can draw from the 10v pad?

   Reply
   1. 

      pika
      2023年 8月 15日

      In theory, the DCDC supports a maximum 3A output, but considering the entire PCB system, and the small area, the heat is easy to accumulate together, it is recommended that the flight should not exceed 2.2A use, do not have no air heat for a long time, should be powered on and take off immediately.

      Reply
5. 

   konst
   2023年 8月 13日

   how do i turn the vtx power on and off?

   Reply
   1. 

      pika
      2023年 8月 15日

      hi,
      You can try the following,
      TIPS: If you use VTX+ to Power your DJI remote controller and O3 air unit or Caddx vista, Don’t enable
      this ON/OFF Pit switch to Keep it Power ON by default.

      The VTX on-off Pit switch can completely turn OFF the video transmitter using a switch on your RC
      transmitter.

      This VTX+ ON-OFF switch can be enable using USER1 in mode tab in Betaflight configure the AUX??
      Range to your want.

      Reply